California prop 65 warning: This product contains chemicals, including lead, known to the State of California to cause cancer and birth defects or other reprocutiove harm. Wash hand after use.
Advantage of RainPro Rain Barrel Spigot Design: You don't need to reach inside of the barrel to install. You only need a small opening(Bung hole is big enough) to install.
Install in 6 easy steps: Drill, Drop, Pick, Tighten, Wrap and Tighten.
Tools needed: Pipe Wrench or Channellock Pliers, Power Drill, 1-1/4 inch Hole Saw, PTFE Thread Tape
Drill 1.25 inch hole on rain barrel, Center the hole 2-3 inch above the bottom(use eye protection when operation power tool)
Drop the bulkhead fitting male piece with gasket in to the barrel
Roll the barrel, pick up the fitting from outside
Install bulkhead nut, turn COUNTER clockwise to tighten
Wrap about 5 rounds of tape on the spigot thread Insert the spigot and tighten
Click the icons below to see detail.
Related article :
Type somethings in the text box below to begin searching