RainPro Brass Rain Barrel Spigot with Bulkhead Fitting

Tags: RainPro Spigot, RainPro Brass Spigot, Rain Barrel Spigot, Spigot with Bulkhead Fitting

RainPro Brass Rain Barrel Spigot with Bulkhead Fitting




Strong UV resistant polyethylene construction.

California prop 65 warning: This product contains chemicals, including lead, known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hand after use.

Installation Instruction:
Tools needed: Pipe Wrench or Channellock Pliers, Power Drill, 1-1/4 inch Hole Saw, PTFE Thread Tape
Drill 1.25 inch hole on rain barrel, Center the hole 2-3 inch above the bottom(use eye protection when operation power tool)
Drop the bulkhead fitting male piece with gasket in to the barrel
Roll the barrel, pick up the fitting from outside
Install bulkhead nut, turn COUNTER clockwise to tighten
Wrap about 5 rounds of tape on the spigot thread Insert the spigot and tighten


Click the icons below to see detail.

Related article :


Type somethings in the text box below to begin searching